v1rev 42013-10-16IEC 61298-2 MOD
non-conformity (terminal-based)
0112/2///61987#ABB804
non-conformity determined by drawing a straight line so that it coincides, with the average calibration curve at the upper range value and at the lower range value
- Used by classes
- 8
- Code
ABB804- Data type
- REAL_MEASURE_TYPEmeasure
- Unit
- UAA000 UAA000
8 / 8
ABC067Accuracy expressed as a percentage [1]ABC068Accuracy expressed as a percentage [2]ABE365Accuracy expressed as a percentage [3]ABE702Accuracy expressed as a percentage [4]ABG352Accuracy expressed as a percentage [7]ABG353Accuracy expressed as a percentage [5]ABJ595Accuracy expressed as a percentage [6]ABP013Accuracy expressed as a percentage [I/O module]
All properties31#
- Version
- 1
- Revision
- 4
- Preferred name
- non-conformity (terminal-based)
- Definition
- non-conformity determined by drawing a straight line so that it coincides, with the average calibration curve at the upper range value and at the lower range value
- Definition source
- IEC 61298-2 MOD
- Note
- The term non-conformity (terminal based non-conformity, independent non-conformity, and, zero based non-conformity) should be used for devices which have a non-linear input-output, relationship (e.g., logarithmic, square root, etc.). The non-conformity is determined and presented using the same procedures as for nonlinearity.
- Definition class
- 0112/2///61987#ABA000Equipment for industrial-process automation
- Unit structure
- %
- Initial value
- 0112/2///62720#UAA000 UAA000
- Responsible committee
- SC65E – IEC 61987
- Published in
- NON_DEPENDENT_P_DET
- Status level
- Standard
- Version release date
- 2018-03-28
- Revision release date
- 2013-10-16
- Version initiation date
- 2016-09-30
- Original definition date
- 2013-09-27
- Change request ID
- C00004
- C017
- C018
- C019
- MDC_P022
- REAL_MEASURE_TYPE