Structural design of a pneumatic linear actuatorKonstruktiver Aufbau eines pneumatischen Hubantriebs

material of which a diaphragm is made

ability to set a device to perform a particular type of action

volume of actuator at zero travel

area of a diaphragm or piston to be taken into account when calculating force or torque at 0% travel

force of an actuator spring at zero travel

tension of an actuator spring at full travel

material from which the piston sealing rings are made

range of gauge pressure applied to the actuator within which the nominal travel is performed

number of springs built into a device

classification of a pneumatic actuator according how the working fluid acts on the diaphragm or piston

output change to a given input signal

classification of the fluid of an actuator transmitting the actuating force according to its chemical composition

classification of the action of an actuator according to its behaviour in the event of failure of the actuating force

classification of a pneumatic actuator according to the form of the actuating element

classification of a spring compartment venting according to its mechanical construction and venting fluid

volume of actuator medium required for one full working stroke

for reference purposes, amount of movement required by a linear-acting actuator to change from its fully open to its fully closed position

material of which the cylinder is made

area of a diaphragm or piston to be taken into account when calculating force or torque at 100% travel

range of gauge pressure applied to the actuator under operating conditions

@number of forces by actuation fluid pressure

reference to block ABE436

reference to block ABE441

reference to block ABU554