Structural design of a pneumatic rotary actuatorKonstruktiver Aufbau eines pneumatischen Schwenkantriebs

material of which a diaphragm is made

for reference purposes, amount of movement required by a rotary-acting actuator to change from its fully open to its fully closed position

ability to set a device to perform a particular type of action

volume of actuator at zero travel

area of a diaphragm or piston to be taken into account when calculating force or torque at 0% travel

material from which the piston sealing rings are made

torque of the spring at highest angular travel

torque of the spring at lowest angular travel

range of gauge pressure applied to the actuator within which the nominal travel is performed

number of springs built into a device

classification of a part turn actuator according to its mechanical construction

classification of a pneumatic actuator according how the working fluid acts on the diaphragm or piston

torque of an actuator spring for zero travel

torque of an actuator spring for full travel

output change to a given input signal

classification of the fluid of an actuator transmitting the actuating force according to its chemical composition

classification of the action of an actuator according to its behaviour in the event of failure of the actuating force

classification of a pneumatic actuator according to the form of the actuating element

classification of a spring compartment venting according to its mechanical construction and venting fluid

volume of actuator medium required for one full working stroke

material of which the cylinder is made

area of a diaphragm or piston to be taken into account when calculating force or torque at 100% travel

range of gauge pressure applied to the actuator under operating conditions

@number of torques by actuation fluid pressure

reference to block ABE439

reference to block ABE441

reference to block ABU554