Structural design of a plumb bob level transmitterKonstruktiver Aufbau eines Lotsystems

precautions taken or to be taken during manufacture of the device regarding wetted parts to ensure its safe operation under special operation conditions

classification of a component surface finish according to the method used to achieve it

tightness of a pressure or vacuum housing expressed in terms of the leakage rate to or from its environment

classification of a seal according to its construction

@number of additional wetted parts materials

finishing specification of a surface expressed as roughness, either as a maximum depth or in a standardized roughness dimension

@number of material of wetted inner seals

classification of a feedthrough according to the mechanical design

reference to block ABC339

reference to block ABC403

smallest extent of a zone that exists immediately below a probe, within which measurement is not possible

classification of a sensor weight according to its mechanical design

material of which the sensor weight is made

length of a cable or tape not including any devices or components attached

material of which the cable or tape is made

classification of a cable or tape wiper to clean the cable or tape according to its mechanical design

for a plumb bob level transmitter, length of a cable or tape wiper

largest inside height a nozzle which still allows a device or a device component to be mounted or to operate within specifications

highest tractive force a motor can exert

number of measuring cycles per time

length of a nozzle extension required to enable the device function

smallest distance a probe must travel in order to enable the device function

reference to block ABU458