value list diagnostic results of valves
list of values for specifying the diagnostic results of valves
- Terms
- 28
- Used by properties
- 1
Terms28#
term indicating load for opening low limit exceeded
term indicating load for opening high limit exceeded
term indicating stiction low limit exceeded
term indicating stiction high limit exceeded
term indicating fieldbus communication failure rate limit exceeded
term indicating daily reversal trend limit exceeded
ABN880calibration recommendedterm indicating calibration recommended
term indicating dynamic state deviation limit exceeded
term indicating supply pressure limit exceeded
term indicating temperature limit exceeded
ABN884hunting detectedterm indicating hunting detected
term indicating steady state deviation limit exceeded
term indicating spool valve problem detected
term indicating position sensor out of range detected
term indicating device in reduced performance mode
term indicating supply pressure too low for single acting actuator
term indicating valve position high limit exceeded
term indicating valve position low limit exceeded
term indicating pressure sensor failure detected
term indicating spool valve sensor failure detected
term indicating temperature sensor failure detected
term indicating electronics failure detected
term indicating pneumatics problem detected
term indicating friction problem detected
term indicating position sensor failure detected
term indicating pre-stage failure detected
term indicating internal communication failure detected
ABI407othersterm indicating addtional value options
Metadata#
- Version
- 2
- Revision
- 1
- Status
- Standard
- Publisher
- IEC
- Published in
- IEC 61987
- Responsible committee
- IEC/SC 65E
- Change request
C00179- Dates
- Current version: 2025-09-15
- Current revision: 2025-09-15