r_bend/d_outv1rev 62011-02-15
bending radius factor
0112/2///61360_4#AAF471
minimum and typical ratio of the bending radius expressed as a multiple of the nominal outside diameter
- Used by classes
- 1
Also appears in1#
Entities with the same name in other dictionaries:
- Code
AAF471- Data type
- LEVEL(MIN,TYP) OF REAL_MEASURE_TYPE
- Unit
- UAA915 UAA915
Version history6#
IEC CDD records every published revision of each entity — version number, status, timestamp, and the change request that introduced it. OpenCDD captures the full chain of custody from cdd.iec.ch; the entry marked Current is the one rendered on this page.
All properties23#
- Version
- 1
- Revision
- 6
- Preferred name
- bending radius factor
- Short name
- r_bend/d_out
- Definition
- minimum and typical ratio of the bending radius expressed as a multiple of the nominal outside diameter
- Remark
- The allowed radius is defined as AAF470 and the outside diameter is defined as AAE022
- Definition class
- 0112/2///61360_4#AAA001component
- Unit structure
- 1
- Drawing reference
- NR2..3.3
- Initial value
- 0112/2///62720#UAA915 UAA915
- Responsible committee
- TC3
- Publisher
- IEC
- Published in
- IEC 61360-4-DB
- Published in
- NON_DEPENDENT_P_DET
- Status level
- Standard
- Version release date
- 2015-08-17
- Revision release date
- 2011-02-15
- Version initiation date
- 2015-08-17
- Original definition date
- 2006-09-14
- MDC_P022
- LEVEL(MIN,TYP) OF REAL_MEASURE_TYPE
- MDC_P025_1
- r_bend}/d_out}
- MDC_P040
- T03