Skip to content
OpenCDD
r_bendv2rev 72011-02-15

bending radius

0112/2///61360_4#AAF470

minimum and typical value of the allowed radius measured to the centre-line of the conductor when bending it into a planar curve

Used by classes
1
property
Code
AAF470
Data type
LEVEL(MIN,TYP) OF REAL_MEASURE_TYPE
Unit
UAA726 UAA726
Used by classes (1)

Version history4#

  1. Current rev 07
    17 Aug 2015 · 15:40 UTC by BATCH 00000917
    View on cdd.iec.ch ↗
  2. superseded rev 06
    23 Jul 2015 · 11:08 UTC by BATCH 00000907
    ↓ Version JSON
    View on cdd.iec.ch ↗
  3. superseded rev 05
    22 Jul 2015 · 14:21 UTC by BATCH 00000904
    ↓ Version JSON
    View on cdd.iec.ch ↗
  4. superseded rev 04
    31 Aug 2011 · 17:08 UTC by BATCH 00000744
    ↓ Version JSON
    View on cdd.iec.ch ↗

IEC CDD records every published revision of each entity — version number, status, timestamp, and the change request that introduced it. OpenCDD captures the full chain of custody from cdd.iec.ch; the entry marked Current is the one rendered on this page.

Metadata#

Note
Applying a smaller bending radius than the minimum value may result in damaging the conductor, affecting its function or shorten its lifetime
Remark
The minimum value applies to a single bending of a conductor and the typical value to the multiple bending of a conductor. The minimum bending radius is often implemented using a template.
Version
2
Revision
7
Status
Standard
Publisher
IEC
Published in
IEC 61360-4-DB
Responsible committee
SC3D
Dates
  • Original: 2006-09-11
  • Current version: 2011-02-15
  • Current revision: 2015-08-17