v1rev 42013-10-16IEC 61298-2 MOD
non-conformity (terminal-based)
0112/2///61987#ABB804
non-conformity determined by drawing a straight line so that it coincides, with the average calibration curve at the upper range value and at the lower range value
- Used by classes
- 8
- Code
ABB804- Data type
- REAL_MEASURE_TYPEmeasure
- Unit
- UAA000 UAA000
8 / 8
ABC067Accuracy expressed as a percentage [1]ABC068Accuracy expressed as a percentage [2]ABE365Accuracy expressed as a percentage [3]ABE702Accuracy expressed as a percentage [4]ABG352Accuracy expressed as a percentage [7]ABG353Accuracy expressed as a percentage [5]ABJ595Accuracy expressed as a percentage [6]ABP013Accuracy expressed as a percentage [I/O module]
Version history4#
IEC CDD records every published revision of each entity — version number, status, timestamp, and the change request that introduced it. OpenCDD captures the full chain of custody from cdd.iec.ch; the entry marked Current is the one rendered on this page.
Metadata#
- Note
- The term non-conformity (terminal based non-conformity, independent non-conformity, and, zero based non-conformity) should be used for devices which have a non-linear input-output, relationship (e.g., logarithmic, square root, etc.). The non-conformity is determined and presented using the same procedures as for nonlinearity.
- Source document
- IEC 61298-2 MOD
- Version
- 1
- Revision
- 4
- Status
- Standard
- Responsible committee
- SC65E – IEC 61987
- Change request
C00004- Dates
- Original: 2013-09-27
- Current version: 2013-10-16
- Current revision: 2016-09-30